Figure 13. Attaching table brace.
8.Thread one M6-1 hex nut halfway onto each of the two cap screws, as shown in Figure 14.
Figure 14. Hex nut threaded halfway onto cap
screw.
9.Insert the two cap screws into the table run- ners so the heads are facing outward, and tighten the remaining two hex nuts onto the ends, as shown in Figure 15. Note—These cap screws act as the table stops when the table is slid backwards.
Figure 15. Cap screws installed in table
runners.
H6246 Meat Cutting Bandsaw |