Grizzly H6246 instruction manual Meat Grinder, Test Run, To install the meat grinder

Meat Grinder
Components and Hardware Needed:	Qty
Meat Grinder Assembly	1
Hex Bolt M8-1.25 x 60	1
Hex Nut M8-1.25	1
Tools Needed:	Qty
Wrench or Socket 13mm	2
To install the meat grinder:

1.Make sure the fork inside the meat grinder lines up with the tang inside of the housing that is mounted on the saw body, and slide the meat grinder all the way onto the housing (Figure 19).

Figure 19. Meat grinder installation.

2.Insert the hex bolt through the bolt hole on the meat grinder assembly and fasten securely with the hex nut.

Allways remove the meat grinder when it is not being used. Failure to do so may result in damage to the meat grinder, because there is no lubrication source without meat being processed.

Test Run

Once assembly is complete and adjustments are done to your satisfaction, you are ready to start the machine.

Turn the machine ON. Make sure that your finger is poised on the OFF button just in case there is a problem. The bandsaw should run smoothly with little or no vibration or rubbing noises. Strange or unnatural noises should be investigated and corrected before operating the machine further.

Run the Model H6246 for a short time to ensure that the moving parts are working properly with no excessive vibration. If any problems develop, correct them before any further use the machine.

If you cannot locate the source of unusual noises, please contact our service department at (570) 546-9663.

H6246 Meat Cutting Bandsaw -19-