Angle Pointer |
| Miter Gauge |
|
|
|
|
|
|
Once the positive stops have been set, the angle pointer will require adjusting. To adjust the angle pointer:
1.The angle pointer is located behind the arbor height hand wheel. Figure 24. (hand wheel removed for clarity)
Angle Pointer
Figure 24.
2.Turn the arbor tilting hand wheel until it stops on the 90° positive stop.
3.Loosen the pointer and set it to ''0'' on scale. Tighten the screw.
4.Turn the arbor tilting hand wheel until it stops on the 45° stop.
5.If the pointer is set on 45˚, skip to the next adjustment. If it does not point to 45°, repeat steps
To adjust the miter gauge so it is perpendicular to the saw blade:
1.Loosen the lock knob on the miter gauge and place a square against the face of the miter body and the blade.
2.Adjust the miter body until there is no space between the square and the blade. Tighten the lock knob.
3.With the stop link in the up position, loosen the jam nut and adjust the stop screw until it is seated against the stop link. Figure 25.
4.Now loosen the setscrew on the left front side of the miter bar, adjust the pointer to 90˚ and retighten the setscrew.
5.To adjust to 45˚, follow steps
6.After rotating the miter body from 45˚ to 90˚ and back a few times, double check your adjustments at both angles to assure that you have accurately set your miter gauge.
Jam Nut
Stop Screw
Stop Link
Figure 25.
|
|
|
|
|
|
|
|
|
|
|
|
G1023 | |||