3.Next, set a straightedge against the face of the saw blade and the blade guard. Figure 10. Loosen and adjust the rear blade guard bracket to set the alignment at the rear, then add washers as necessary between the split- ter and the front mounting bracket to gain adjustment in the front.
Figure 10.
4.Recheck guard alignment to the blade and to the table top. Adjust as necessary and tight- en down all the bolts before use.
Fence Rails
The rails should extend to the right of the saw and are attached to the table top with cap screws and dished spacers. The rails come packed in a sep- arate box. To mount the rails:
1.Attach the front and rear rails to the drilled and tapped holes on each extension wing. Figure 11. Be sure that the rail with the scale is mounted on the front side of the machine, with the markings facing up.
2.Insert the round, plastic plugs into the ends of each rail.
Figure 11.
|
|
|
|
|
|
|
|
|
|
|
|
G1023 | |||