Grizzly G1023 instruction manual Lubrication, To adjust V-belt tension

Page 27

To adjust V-belt tension:

1.Loosen the motor mount bolt. Figure 38.

2.Shift the motor up or down to increase or decrease the V-belt tension. Tighten the motor mount bolt.

3.Check the V-belt tension again. Ensure that the motor pulley and arbor pulley are lined up.

Motor Mount Bolt

Figure 38.

To replace the V-belts:

1.Remove the blade.

2.Adjust the arbor so it is down all the way and in the straight up position.

3.Loosen the motor mount bolt. Prop the motor up with a board so the V-Belts stay loose on the pulleys.

4.Pull off the old V-belts and replace them with new ones. Have the number from the belt ready when calling the service department for replacements.

5.Remove the board and adjust the V-belt ten- sion.

6.Tighten the motor mount bolt.

Lubrication

The shielded ball bearings in the motor and throughout most of the model G1023 require no further lubrication during their lifetime. When they do wear out, replacements can be obtained through the Grizzly Parts Department.

Your saw requires lubrication in several other locations, however. Lubricate the areas indicated below every 12 months.

1.Blade angling trunnions. These should be lubricated with 6 or 7 drops of light machine oil.

2.Blade height trunnion. This should also be lubricated with 6 or 7 drops of light machine oil.

3.The two (2) worm gears should be lubricat- ed with a automotive wheel bearing grease. The blade angle worm gear is not shown in

Figure 39.

These points can be reached by removing the table. Check all adjustments when finished lubri- cating.

Figure 39.

 

 

 

 

 

 

 

 

-26-

 

 

G1023 Heavy-Duty Table Saw

 

 

Image 27
Contents HEAVY-DUTY Table SAW Table Of Contents Safety Instructions For Power Tools SafetyAdditional Safety Instructions For Table Saws General Information Unpacking Piece Inventory Clean up Site Considerations Grounding Beginning Assembly Hand Wheels AssemblySwitch Extension Wings Guard Support Shaft Blade Blade Guard Fence Rails Fence Table Inserts Page Miter Slot to Blade Adjustments90˚ Positive Stop 45˚ Positive Stop To adjust the 45 positive stop boltAngle Pointer Miter Gauge Fence Blade Alignment Pre-Run Check Test run OperationsBlade Selection Crosscutting Ripping Table and Wings Belt MaintenanceLubrication To adjust V-belt tensionClosure 80-1 Cabinet Setscrew Guard Page Fence Machine Data Symptom Possible Cause Corrective Action Trouble Shooting GuideWarranty and Returns