1.Install the table insert by putting your fingers into the finger holes of the insert and lifting the front to install it as shown in Figure 14. There is a small pin at the back of the insert which fits into a hole in the back edge of the blade cavity. Note: The blade will not be exactly centered in the insert slot. This is normal. This positioning allows the blade to tilt a full 45° without hitting the insert.
Figure 14.
2.Make the insert flush with the table top by adjusting the four setscrews in the insert. Check flushness with a straight edge. Figure 15.
Figure 15.
3.A drop of glue or Loctite® on the threads of the setscrews will keep the setting from changing.
4.If the blade hits the edge of the insert when raised, the blade is out of alignment. See
Section 3 page 19.
|
|
|
|
|
|
|
|
|
|
|
|
G1023 | |||