SECTION 4: ASSEMBLY
Beginning Assembly
!Disconnect power to the machine when perform- ing any maintenance,
assembly or adjust- ments. Failure to do this may result in serious personal injury.
Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.
Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.
Most of your Model G5959Z has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.
TOOLS REQUIRED: You will need a high quality square, a long straightedge, 10mm, 12mm, 14mm open end wrenches and a 3mm hex wrench.
G5959Z 12"
Extension Wings
Inspect the extension wings for burrs or foreign material that may inhibit assembly. The mating edges of the wings and table must be clean, smooth, and flat. Use a wire brush or file if nec- essary to clean up the edges.
The wings represent a
very heavy load. Improper lifting tech- niques or inadequate lift- ing assistance could result in serious injuries.
NOTICE
The right and left wings are not the same. The left wing has two tapped holes on the outside edge, the right has a tapped hole on the front and back edge. If the wings are not installed in their correct location, the fence cannot be attached.
1.Disconnect the table saw from the power source.
2.Attach the left wing to the table using three hex head bolts and flat washers. Adjust the wing reasonably flush with the table. Do not tighten the bolts.
3.Attach the right wing to the table using three hex head bolts and flat washers. Adjust the wing reasonably flush with the table. Do not tighten the bolts.
4.Align the top of the wing flush with the table top directly above the front bolt, and tighten the front bolt. The front edge of the extension wing should also be flush with the front edge of the table.
5.Raise or lower the rear of the extension wing until the middle of the wing is flush with the table top. Tighten the middle bolt.