SECTION 6: OPERATIONS
Pre-Run Check
Before you begin to use your Model G5959Z 12"
1.Are all the fasteners tight?
2.Is the blade mounted correctly?
3.Is the saw stable?
4.Is it wired properly?
5.Is your electrical system properly config- ured?
6.Are the
7.Is the guard assembly installed and func- tional?
8.Have you checked the saw blade clearance when it is adjusted to varying angles and depths?
9.Have you read all warnings and directions regarding the operation of this machine?
!Disconnect power to the machine when perform-
ing any maintenance, assembly or adjust- ments. Failure to do this may result in serious personal injury.
Test Run
Always wear a dust mask when operating the G5959Z. Using this machine produces saw- dust which may cause allergic reactions or res- piratory problems.
Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.
Wear safety glasses dur- ing the entire operations process. Failure to com- ply may result in serious personal injury.
1.Face the table saw and stand to the right of the blade path.
2.With one finger on the START button and one finger on the STOP button, turn the saw on. Be ready to turn it off in case of mishap.
3.Watch and listen to the saw. Note whether there are any unusual sounds or excessive vibrations.
4.Turn off the saw. If anything is abnormal, stop and fix the problem. If a problem exists that is beyond the scope of this manual, call our service department. If the saw is behav- ing normally, prepare to make a cut accord- ing to the instructions outlined in the follow- ing sections.
G5959Z 12" |