Miter Gauge | Rip Fence | |
|
|
|
To adjust the miter gauge so it is perpendicular to the saw blade:
1.Loosen the lock knob on the miter gauge and place a square against the face of the miter body and the miter blade.
2.Adjust the miter body until there is no space between the square and the miter blade. Tighten the lock knob.
3.With the stop link in the up position, loosen the jam nut (Figure 26) and adjust the stop screw until it is seated against the stop link.
| Miter Body |
| Jam Nut |
Pointer | Stop Screw |
| |
Setscrew |
|
| Miter Blade |
Stop Link |
|
Figure 26. Miter gauge assembly.
4.Now loosen the setscrew on the left front side of the miter bar, adjust the pointer to 90¡ and tighten the setscrew.
5.To adjust to 45¡, follow Steps 1-4 using an adjustable square set to 45¡.
6.After rotating the miter body from 45¡ to 90¡ and back a few times, double-check your adjustments at both angles to assure that you have accurately set your miter gauge.
The rip fence included with your Model G5959Z 12" Table Saw is designed to provide excellent ripping accuracy when properly adjusted. There are three main adjustments to concern yourself with: square, parallelism and clamping pressure.
SQUARE
Place a machinistÕs square against the side of the fence. If the square does not remain flush against both the fence and the table, adjust the nylon screws (Figure 27) on top of the bracket at the front of the fence until square.
Nylon Screws |
Figure 27. Nylon adjustment screws.
|
|
|
|
|
|
|
|
|
| G5959Z 12" | |
|
|