Grizzly T21888 Set Up, Unpacking, Assembly, Placement, To assemble the air compressor

Page 10

SECTION 2: SET UP

Unpacking

Your air compressor left our warehouse carefully packed. If you discover the air compressor is damaged after you have signed for delivery, please immediately

call Customer Service at (570) 546-9663 for advice.

Save the container and packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult.

Assembly

To assemble the air compressor:

1.Remove all packing materials and any protective plastic bags and tags from the compressor.

2.Rotate the air filter cap clockwise to make sure the air filter is attached to the cylinder head, as shown in Figure 2.

Air Filter Cap

Figure 2. Air filter attached to

cylinder head.

-8-

3.Remove the oil fill cap (Figure 3) on top of the crankcase and add air compres- sor oil into the hole. When full, the oil level should be in the center of the sight glass.

Oil Fill

Cap

Sight Glass

Figure 3. Oil cap and sight glass location.

Placement

Place the compressor on a stable and level surface in a clear and well ventilated area to prevent the motor from overheat- ing. When using the compressor at a job site or any other location, make sure that an adequate and properly fused power supply is available for this machine. Do not use extension cords with this machine.

The contacts of the compressor pres- sure switch spark when cycling the compressor motor ON and OFF. If any flammable gases are near the switch, ignition and explosion may occur, resulting in severe burns or death. NEVER place the compressor next to flammable liquids, gases, or in a paint spraying or gluing booth.

Model T21888 (Mfg. since 2/10)

Image 10
Contents Gallon Compressor Page Table of Contents Foreword Specifications IntroductionRead this MANUAL. This tool may Maintain Safety GUARDS. YourTion about proper operation of the equipment Wear a RESPIRATOR. This toolUSE Correct AIR Pressure Additional Safety Instructions For Air Compressors Circuit Requirements 110V OperationGrounding Placement SET UPAssembly UnpackingPressure Relief Valve Test on Test Run BreakTo test run and break in the air com- pressor Changing Oil onPressure Regulator Use OperationsTo control the air supply to your tool Operation To use your air compressorG6261-Campbell Hausfeld Water Filter AccessoriesH7274-Campbell Hausfeld Pressure Regulator Schedule MaintenanceDaily before use, perform the following checks Pressure Relief Valve Test Draining TankTo drain water from the tank Troubleshooting ServiceSymptom Possible Cause Possible Solution Model T21888 Mfg. since 2/10 Model T21888 Mfg. since 2/10 To change the oil Changing OilCheck Valve To fix the check valveTo find air leaks Fixing Air LeaksTo fix air leaking around fitting threads Pressure Switch To adjust the pressure switchWhen storing your air compressor, fol- low these guidelines StorageParts Breakdown Parts List DescriptionWarranty Warranty Card Place Stamp Here Name Street CityStateZip