Loading Nails:
Operating Nailer
1.WARNING! Always wear ANSI- approved safety goggles when reloading or performing any other maintenance on Nailer. Other people in the work area must also wear
2.WARNING! Make sure Nailer is not attached to the air hose when load- ing tool.
3.Note: This Nailer only uses 28°
4.Pull the Feeder Shoe (69) all the way to the rear until it latches.
5.Orient a strip of Nails (not included) with tips down and drop the Nails into the Magazine (71).
6.Slide the Nails forward in the Maga- zine. The Magazine will hold 90 Nails.
7.Pull Feeder Shoe backward and then press Lock (75) to allow Feeder Shoe to slide forward against the Nails.
INSERT NAILS
HERE
Trigger (56)
1.Attach the Nailer to the air supply at the Air Plug (83).
2.Start your compressor and check the pressure, making sure you do not exceed the maximum 120 PSI.
3.Rotate the Exhaust Cover (4) so that the exhaust air blast will be directed away from the operator.
4.To fire, place the Nose Safety Guide
(42) of the Nailer on the workpiece.
The Nailer should not fire if the Nose is not depressed.
5.Once depressed, gently and briefly squeeze the Trigger (56) once; one
Nail will be fired.
6.Do not press the Nose against the workpiece with extra force. Allow the tool to do the work. Always allow the tool to recoil off the work surface.
7.When finished using the Nailer, always disconnect the tool from its air supply. Empty the Magazine (71) completely of Nails.
8.Attempt to fire the Nailer into a piece of scrap wood to ensure it is discon- nected and is incapable of firing any
Nails.
9.Make sure to store the Nailer in a clean, dry, safe location out of reach of children.
Magazine
(71)
Feeder Shoe (69)
Nose Safety Guide (42)
Rev 09l
SKU 98917 | For technical questions, please call | Page 10 |