Functional Description, Specifications | Harbor Freight Tools 98917

Functional Description

Specifications

	Working Air	70-120 PSI
	Working Air	(Depending on nail length and
	Pressure	(Depending on nail length and
	Pressure	wood density)
		wood density)
	Air Inlet	1/4” -18 NPT
	Magazine	90 Nails (Not Included)
	Capacity	90 Nails (Not Included)
	Capacity
	Magazine Angle	28°
	Air	8 CFM @ 60 PSI
	Consumption	10 CFM @ 100 PSI
	Safety Trigger	Sequential
	Fastener Type	Paper-Collated Clip Head Nails
	Fastener Type	Wire-Collated Full Head Nails
		Wire-Collated Full Head Nails
	Nail Type	0.113” to 0.131” Shank Dia.
	Nail Type	2-3/16” to 3-9/16” L / 28° Angle
		2-3/16” to 3-9/16” L / 28° Angle

Air Supply

To prevent explosion:

Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.

Initial Tool Set Up/

Assembly

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

Unpacking

When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown throughout the manual as soon as possible.

•This air tool may be shipped with a protective plug covering the air inlet. Remove this plug before set up.

1.Incorporate an in-line oiler, shut-off valve, regulator with pressure gauge, and filter for best service, as shown in the diagram above. An in-line shut- off valve is an important safety device because it controls the air supply even if the air hose is rup- tured.

Note: If an automatic oiler system is not used, add a few drops of Pneumatic Tool Oil to the airline connection be- fore operation. Add a few more drops after each hour of continual use.

2.Attach an air hose to the compres- sor’s air outlet. Connect the air hose to the air inlet of the tool. Other com-

Rev 09l

SKU 98917

For technical questions, please call 1-800-444-3353.

Page 7