Troubleshooting
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect air supply before service.
Problem |
| Possible Solution |
|
|
|
Air leak near top of tool. | 1. | Tighten all screws on the cylinder cap. (See Assy. Diagram.) |
| 2. | Have a qualified service technician install a head valve piston set. |
Tool does not work. | 1. | Check all air connections for leaks. |
| 2. | Make sure to fully depress the nose of the workpiece when |
|
| attempting to fire a nail. |
| 3. | Check for nail jams. Clear the jam if necessary. |
| 4. | Have a qualified service technician check out the tool. |
Sluggish operation. | 1. | Make sure the compressor regulator is set below 120 PSI. Make |
|
| sure the compressor used produces sufficient C.F.M. to operate the |
|
| Nailer. |
| 2. | Check all air connections for leaks. |
| 3. | Have a qualified service technician install a head valve piston set. |
Air leak near bottom of tool. | 1. | Tighten all screws. |
| 2. | Have a qualified service technician replace the bumper or head |
|
| valve piston set. |
Poor return after firing tool. | 1. | Have a qualified service technician clean the interior of the tool and/ |
|
| or replace the bumper or head valve piston set. |
Weak driving force. | 1. | Make sure the compressor regulator is set below 120 PSI. |
| 2. | Check all air connections for leaks. |
| 3. | Have a qualified service technician clean the interior of the tool |
|
| and/or replace the bumper or head valve piston set. |
Poor feed. | 1. | Have a qualified service technician clean the interior of the tool |
|
| and/or lubricate the magazine and install a new magazine spring. |
Tool jamming too often. | 1. | Have a qualified service technician clean the interior of the tool |
|
| and/or lubricate the magazine and install a new magazine spring. |
Other problems. | 1. | Have a qualified service technician check out the tool. |
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect air supply before service.
Rev 09l
SKU 98917 | For technical questions, please call | Page 13 |