Global Machinery Company LS250TS2000W Attaching the wheel axle, Attaching the wheels

Attaching the wheel axle

1. Remove the retaining bolts J and washers from the ends

of the axle.

2.Slide the wheel axle through the holes in the 2 stand legs on the left hand side of the table saw (fig J).

Attaching the wheels
	K
1. Fit the flat washer
(fig K) followed by the
wheel, flat washer and the
spring washer onto the
axle (fig L). Secure the
wheel onto the axle using
the 13mm hex head screw.

2.Repeat for the opposite side.

3.Position the hubcap over

the wheel (fig M) and	L
secure from behind using
5 of the ST4.2 x 13mm
Philips head screws with
flat washers (fig N).
4. Repeat for the opposite
side.
M	N

Fitting and adjusting the	O
rear extension table

1.Remove the 2 self-tapping screws from the end of each rod on the rear extension table (25).

2.Fit the rear extension table into the 2 positioning holes on the back of the table saw (fig 0).

3.Replace the 2 self-tapping screws in each rod to prevent the rear extension table from sliding out.

Attaching the height	P
adjustment handle

1.Fit the blade height adjustment handle (20) onto the blade angle wheel (21) by first placing the metal handle tube onto the handle screw.

2.Place the screw and tube through the handle, and

then fit the washer onto the thread of the screw.

3.Fit the thread of the screw into the thread on the yellow insert of the blade angle wheel (21) and tighten the screw firmly with a 5mm hex key supplied (fig P).

Note. The flat washer should be fitted between the handle (20) and the yellow insert of the blade angle wheel (21).

Fitting the riving knife	Q
and laser assembly

1.Remove the screw securing the table insert (13) and take off the table insert (fig Q).

11