Global Machinery Company LS250TS2000W instruction manual Components, Already fitted on axle, 1213

Page 8

Components

The GMC LS250TS table saw is supplied with the following components:

1.Table saw

2.Riving knife and laser assembly

3. Blade guard

4.Wheels x2

5.Hubcaps x2

6.Rip fence

7. Mitre gauge		2	3
8. Push stick

9. Spanner
10.	Left hand side extension table
11.	Rear extension table
12.	Height adjustment handle with hex screw,
	swivel tube and washer		4	5
13.	5mm Hex key

14.Wheel axle

15.AAA batteries x2

16.2 x 13mm Hex head screws with 4 flat washers

and 2 spring washers for securing wheels to axle	6	7	8	9
(already fitted on axle)

17.10 x ST4.2 x 13mm Philips head screws with

10 flat washers for securing hub caps to wheels

18.4 x ST4.2 x 9mm set screws for securing side extension

tables (already fitted to extension table rods)	11
10

Image 8

Contents 2000W 250mm 10 Table Saw Contents Symbols SpecificationsIntroduction Environmental protectionSafety rules for laser lights General safety instructionsAdditional safety rules for table saws Faulty saw blades have to be replaced immediately Wear goggles Wear earmuffs Wear a breathing mask UnpackingRequired Tools 1213 ComponentsAlready fitted on axle Know your product Table top18 17 1 819Assembly Stand set-upFitting and adjusting Rear extension table Attaching the height Adjustment handleFitting the riving knife Laser assembly Attaching the wheel axleFitting the blade guard Using the mitre gauge holderUsing the push stick holder Adjusting the laser line Folding the standMoving the saw Fig b Lift the blade guard off the riving knifeSwitching on and off Adjusting the blade angleUsing the rip fence DepthUsing the mitre gauge OperationPush sticks KickbackCutting a narrow workpiece Tips to avoid kickbackMaking longitudinal cuts Cutting an extremely narrow workpiece Making bevel cutsMaking cross cuts Replacing the saw BladeMaintenance Power cord maintenance CleaningChanging Batteries Laser generator General inspectionPage GMC Customer Assist