Global Machinery Company LS250TS2000W instruction manual Assembly, Stand set-up

Page 10

Assembly

Stand set-up

1.Place the table saw on the floor (fig A).

2.On the left hand side extension table which was packed separately from the table saw remove the 2 self-tapping screws from the end of each rod.

3.Fit the left hand side extension table into the 2 positioning holes on the left hand side of the table saw, the extension table locking knobs (28) may need to be loosened if it is a tight fit (fig B).

A

 

B

 

 

 

C

 

D

 

 

 

4.Replace the 2 self-tapping screws to prevent the side extension table from sliding out (fig C).

Note: The guide rods can be rotated slightly to gain access to the screw holes.

5.Ensure the left hand side extension table is fully inserted and tighten the extension table locking knobs to secure it in position (fig D).

6.Using the handle on the table saw (4) and the soft grip handle on the lower leg (5) gently tilt

the table saw onto its

E

left hand side.

7.Push the stand locking lever (29) to the left to disengage the stand assembly and fold open the stand legs (fig E).

8.Fully open the stand legs and ensure that the stand

locking lever clicks back into place indicating that

the stand legs are securely F open (fig F ).

9.Using the handle on the table saw (4) and the soft grip handle on the lower leg (5) tilt the table saw onto its stand (fig G).

Important. Use both handles when tilting the table onto the stand. Push down on the

leg handle (5) and pull the G table handle (4).

10.Loosen the lock nut on the adjustable foot (32) and screw the foot in or out until the table saw is stable (fig H & I).

11.Tighten the lock nut.

H

 

I

 

 

 

10

Image 10
Contents 2000W 250mm 10 Table Saw Contents Introduction SymbolsSpecifications Environmental protectionSafety rules for laser lights General safety instructionsAdditional safety rules for table saws Faulty saw blades have to be replaced immediately Required Tools UnpackingWear goggles Wear earmuffs Wear a breathing mask Already fitted on axle Components1213 18 17 1 Know your productTable top 819Assembly Stand set-upFitting the riving knife Laser assembly Fitting and adjusting Rear extension tableAttaching the height Adjustment handle Attaching the wheel axleUsing the push stick holder Using the mitre gauge holderFitting the blade guard Moving the saw Adjusting the laser lineFolding the stand Fig b Lift the blade guard off the riving knifeUsing the rip fence Switching on and offAdjusting the blade angle DepthPush sticks Using the mitre gaugeOperation KickbackMaking longitudinal cuts Tips to avoid kickbackCutting a narrow workpiece Making cross cuts Cutting an extremely narrow workpieceMaking bevel cuts Replacing the saw BladeChanging Batteries Laser generator Maintenance Power cord maintenanceCleaning General inspectionPage GMC Customer Assist