Note. Since blade thickness varies, always make a trial cut in scrap material along the guideline to determine how much, if any, the guideline must be offset to get an accurate cut.
Using the parallel fence guide
The parallel fence allows you to make parallel cuts in a sheet of wood, all at the same width.
CAUTION. Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments.
1.Loosen the parallel fence locking knob (10)
2.Slide the parallel fence (11) through the slots in the base plate (14).
3.Adjust the parallel fence to the required width and secure it in position with the parallel fence locking knob (10).
4.Ensure that the fence rests against the wood along its entire length to give a consistent parallel cut.
Dust extraction
The tool can be connected to a dust extraction system via the dust extraction adaptor (17).
1.Fit the dust extraction adaptor (17) over the dust extraction port (16).
2.Using the two phillips head screws supplied secure the dust extraction port onto the saw.
3.Connect your dust extraction equipment onto the dust extraction adaptor.
Using the REDEYE® system
WARNINGS. Do not stare directly at the laser beam.
Never aim the beam at any person or an object other than the work piece.
Do not deliberately aim the beam at personnel and ensure that it is not directed towards the eye of a person for longer than 0.25s.
Always ensure the laser beam is aimed at a sturdy work piece without reflective surfaces. I.e. wood or rough coated surfaces are acceptable. Bright shiny reflective sheet steel or the like is not suitable for laser use as the reflective surface could direct the beam back at the operator.
Only turn laser beam on when tool is on work piece.
1.Mark the line of the cut on the work piece.
2.Adjust the depth of cut and bevel angle as required.
3.Rest the front edge of the base on the work piece.
4.Switch on the laser beam by pressing the laser light on/off button (4).
5.Start the motor by squeezing the trigger switch (3).
12