Global Machinery Company LS236LS instruction manual Save this Manual for future reference

Page 15

Carefully read the entire Instruction Manual before using this product.

Before returning this product for a Warranty Claim or any other reason Please Call 1300 880 001 (Australia) or 0800 445 721 (New Zealand)

When you make your call, please have the following information at hand:

GMC Product Type GMC Product Code

A GMC Service Engineer will take your call and, in most cases, will be able to solve your problem over the phone.

You are welcome to use this phone-in service to make suggestions or give comments about any GMC product.

With continuing product development changes may have occurred which render the product received slightly different to that shown in this instruction manual. The manufacturer reserves the right to change specifications without notice. Note: Specifications may differ from country to country.

The GMC 777 Helpline operates from 7am to 7pm, 7 days a week (EST). This allows you to contact GMC directly with any queries and technical questions you have regarding

our products.

45–55 South Centre Road

Melbourne Airport

Victoria, Australia 3045

Tel: (03) 8346 1100 Fax: (03) 8346 1200

Save this Manual for future reference.

Image 15
Contents 2300W 235mm 9-1/4 Circular Saw Contents Introduction Description of symbolsSpecifications Dear CustomerWork area General safety rulesPersonal safety Power tool use and careService Additional safety rules for laser lightsCauses and operator prevention of kickback Additional safety rules for circular sawsPage Laser light assembly Laser aperture Trigger switch Know your product12 16 14 21 Unpacking AccessoriesAssembly Adjusting the cutting depthLock the screw with the lock nut Adjusting the bevel settingAdjusting the bevel angle Ensure power is disconnected from the mains socketMark the line of cut on the work piece Adjusting the angle pointerSwitching on and off Making a cutUsing the parallel fence guide Using the Redeye systemDust extraction Changing the blade Align the beam with the line on the work piecePlace saw on its side on a flat surface Maintenance General inspectionRepairs Save this Manual for future reference