Global Machinery Company LS236LS instruction manual Maintenance, General inspection, Repairs

Page 14

Maintenance

1.Keep the tool’s air vents unclogged and clean at all times.

2.Remove dust and dirt regularly. Cleaning is best done with a soft rag or a soft brush. Wear safety glasses to protect your eyes while cleaning.

3.Re-lubricate all moving parts at regular intervals.

4.If the body of the saw needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used but nothing like alcohol, petrol or other cleaning agent.

5.Never use caustic agents to clean plastic parts.

CAUTION. Water must never come into contact with the saw.

General inspection

Regularly check that all the fixing screws are tight. They may vibrate loose over time.

Repairs

Only an authorised service centre should replace the cordset or effect other repairs. If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard.

14

Image 14
Contents 2300W 235mm 9-1/4 Circular Saw Contents Dear Customer Description of symbolsSpecifications IntroductionPower tool use and care General safety rulesPersonal safety Work areaAdditional safety rules for laser lights ServiceAdditional safety rules for circular saws Causes and operator prevention of kickbackPage 12 16 14 21 Laser light assembly Laser aperture Trigger switchKnow your product Adjusting the cutting depth AccessoriesAssembly UnpackingEnsure power is disconnected from the mains socket Adjusting the bevel settingAdjusting the bevel angle Lock the screw with the lock nutMaking a cut Adjusting the angle pointerSwitching on and off Mark the line of cut on the work pieceDust extraction Using the parallel fence guideUsing the Redeye system Place saw on its side on a flat surface Changing the bladeAlign the beam with the line on the work piece Repairs MaintenanceGeneral inspection Save this Manual for future reference