Grizzly H7951, H7950 Unloading Nails, Rotating Exhaust Cover, To remove unused nails

Unloading Nails

To remove unused nails:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Point the nailer away from you and all bystanders.

3.Open the magazine cover (as shown on Page 8) and lift the nails from maga- zine.

4.Close the magazine cover to keep the magazine assembly clean until the nailer is reloaded.

Rotating Exhaust

Cover

The exhaust cover rotates as needed to direct the exhaust away from you.

To rotate the exhaust cover:

1.Use the 4mm hex wrench to loosen the exhaust cover cap screw as shown in Figure 10.

Exhaust

Cap Screw

Figure 10. Loosening the exhaust cap

screw.

2.Rotate the exhaust cover by hand to aim the exhaust port in the desired direction.

3.Tighten the exhaust cover cap screw.

-10- H7949/H7950/H7951 Nailer