Grizzly H7951, H7950 instruction manual Cleaning & Lubricating, CleaningLubricating

Page 16

CLEANING & LUBRICATING

CleaningLubricating

Use an automotive grade solvent such as Sprayway C-60®(G2544 in the Grizzly catalog) to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again.

Do not allow dust, chips, or sand into the air connectors or into the body of the nail- er; this may result in leaks and damage to the nailer and the air couplings.

Never use gasoline to clean this tool. Use extreme caution when using any solvent cleaner. Always clean the tool in a well-ventilated area and never if sparks or open flames are present. Remember that electrical machinery can produce sparks during normal operation. Ignoring this warning can cause serious personal injury or even death!

Special pneumatic tool oil has been included with your new Grizzly nailer to help maintain its useful life. Place two to six drops of oil in the nailer air inlet (as shown in Figure 15) every 2 hours of continuous use.

Wipe off any excess oil near the nailer exhaust to avoid dust build-up. When the oil that was included with your nailer has been completely used, replace with Grizzly Model G2820 Pneumatic Tool Oil.

An efficient alternative to oiling your tool by hand is to install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer will not be neces- sary. Just make sure there is always oil in the lubricator.

Figure 15. Lubricating the nailer at the

air inlet.

-14-

H7949/H7950/H7951 Nailer

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Model H7949/H7950/H7951 Safety Safety Instructions For Pneumatic ToolsBefore Operating This Equipment Mation about proper operation of the equipmentAlways Wear Ansi Approved Hearing Protection Additional Safety Instructions for Nailers H7949/H7950/H7951 Nailer Model H7949 Specifications Model H7950 SpecificationsIntroduction Foreword Model H7951UnpackingInventory SetupModel H7949/H7950/H7951 Inventory Compressed Air System Testing Safety Nose Mechanism To verify that the safety nose is working correctlyModel H7949/H7950 Loading Nails OperationsTo load nails in your nailer Model H7951 Loading Nails Unloading Nails Rotating Exhaust CoverTo remove unused nails To rotate the exhaust coverUsing the Nailer To operate your nailerAdjusting Depth To adjust the nail depthClearing Jammed Nails To clear a jammed nail from the dis- charge areaReplacing Pistons/O-Rings To replace a piston and O-ringsCleaning & Lubricating CleaningLubricatingH7949 Parts Breakdown H7949 Parts List DescriptionPilot Valve H7950 Parts Breakdown H7950 Parts List PH7950094 H7951 Parts Breakdown H7951 Parts List Carbide Chip Troubleshooting Symptom Possible Cause SolutionWarranty and Returns Page Warranty Card Name Street CityStateZip BOX BELLINGHAM, WA
Top Page Image Contents