Assembly
Except for the operating lever, the Model T10726 has been assembled and adjusted at the factory.
To attach the operating lever:
1.thread the operating lever shaft (see Figure 3) into the eccentric shaft, and tighten it with the wrench.
Operating |
Lever Shaft |
Eccentric |
Shaft |
Figure 3. Operating lever shaft installed.
2.slide the operating lever onto the lever shaft (see Figure 4), and secure it with the pre- installed set screw.
Set Screw
Operating
Lever
Figure 4. Operating lever attached.
Model T10726 (Mfg. Since 12/12)
Vise & Workbench
Setup
The forces exerted on the brake during operation are substantial. The brake must be firmly secured in a vise (see Figure 5) that is solidly attached to a workbench that will support the weight and dynamic pressures of the operation (refer to Page 12 for workbench and vise options from Grizzly).
Mount the brake by tightening the vise jaws against the lug at the bottom of the brake.
Note: Use pieces of cardboard, wood, or padded jaw faces between the vise jaws and the vise lug to prevent surface damage to the brake.
Vise
Lug
Figure 5. Example of Model T10726 secured in
vise mounted to a workbench.
Make sure the workbench that the brake will be mounted on is stable and can support the weight of the tool, the workpiece, and the forces exerted during operation.