Panasonic PT-52LCX16, PT-61LCX16 manual First Time Setup, Language, Auto program, Basic Operation

First Time Setup

For your convenience, First Time Set up menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures displayed on-screen for setting up the features.

Language

The language of the on-screen display is set to English as the factory setting.

You can select English, Spanish or French as the on-screen displays language.

1	Press to select “Language”.
	Press to display Language
	screen.

First time setup

Language

Auto program

2

Press to select “English,” “Español” or “Français”.

		Language
		Language ◄	English	►
3
	Press to go to previous
	screen. Or, select		icon,

then press OK for same results.

Auto program

You can scan All (Analog and Digital) channels. If needed, follow the menus and procedures displayed on-screen for setting up the features. You can also make the settings in Setup menu.

1	Press to select “Auto
	program”.
	Press to display Auto program
	screen.
	First time setup

Language

Auto program

2	Press to select “ANT In”.
	Press to select “Cable” or
	“Antenna”.
			Auto program
			ANT In	◄	Cable	►
			Mode		All
			Start scan
3	Press to select Mode.
	Press to select “All” or
	“Analog”.
			Auto program
			ANT In		Cable
			Mode	◄	All	►
			Start scan
4	Press to select “Start scan”.
	Press to start.
	Channels available for
	reception will be set
	automatically.
			Auto program
			ANT In		Cable
			Mode		All
			Start scan
		Now scanning analog channel...
		Progress

5 After Auto program is complete, the unit will return to Manual program mode. To place the channels that were located by auto scan in memory, move the cursor to “Apply” and press OK. (p. 30-31)

If OK is not pressed after selecting APPLY, the channels will not be memorized.

Notes:

•After “Auto program” is completed the unit tunes to the first channel found during “Auto program”.

•If setup is incomplete, check connection of Antenna/Cable to the RF IN Terminal, then try “Auto program” again. (p. 29)

•“Auto program” must be done when you select the input signal for the first time or whenever you change the antenna configuration.

•Depending on conditions, “Auto program” may take a while.

Basic Operation

25