Panasonic PT-52LCX16 manual Remote Control Battery Installation, Helpful Hints, Getting Started

Remote Control Battery Installation

Requires two AA batteries (supplied).

1. Slide the battery cover in direction of arrow.

2. Install batteries in the battery compartment.

•Battery polarity (+) and (-) must match the markings inside the compartment.

Two AA size

3. Slide the battery cover until it snaps shut.

CAUTION

Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the Remote Control.

Observe the following precautions:

1.Always replace batteries with a pair of new ones.

2.Do not combine a new battery with an old one.

3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when the Remote Control acts sporadically or stops operating the Projection Display set.

Helpful Hints:

(1)Frequent Remote Control users, choose long-lasting Alkaline batteries as replacements.

(2)Whenever batteries are removed, you may need to reset Remote Control infrared codes.

We suggest making a note of the codes on page 58 prior to setting up the remote.

Reset All Memory Functions

Use when moving unit to a new location, or when First Time Setup needs to be done over.

Press together the VOL- button on the unit and OK button on the Remote Control for more than

3 seconds. Unit shuts itself off when reset is done.

•POWER indicator flashes red. After flashing stops, unplug the unit then

plug it back in and turn power ON.

Note:

•When using “Control with HDMI (HDAVI Control)”, with the device connected, set “Ctrl with HDMI” first to “Off” and then “On” using the Setup Menu. (p. 56)

Getting Started

7