B. UNLOADING FASTENERS
Fasteners should be removed each time you finish using the gun.
To unload the gun:
1.Disconnect the air hose if still connect- ed.
2.Press the button inside the spring handle finger hole. Figure 5. Guide the spring handle to the front of the gun. DO NOT
LET THE SPRING HANDLE SNAP BACK TO ITS RESTING POSITION!
3.Press down on the nail stop and slide the nails out through the nail slot. Figure 6.
Nail Stop |
Spring Handle |
Spring Handle Button |
Figure 5 shows a closeup of the spring handle button.
Press to release pressure.
Nail Stop
Spring Handle
VII. OPERATIONS
C. CONNECTING TO AIR
To connect the air hose to the air nozzle at the rear of the gun:
1.Pull back on the female hose connector sleeve.
2.Press the fitting onto the nail gun air noz- zle and release the sleeve. The female fitting will lock onto the male gun fitting.
3.Listen for any air leaks. If no leaks are detected, you are ready to test fire the gun.
Always disconnect the air supply when the gun is not in use because (1) a pressurized gun is dangerous and (2) constant pres- sure will reduce the life of the
Prior to operating this nail gun, ensure that all safety procedures are read and understood. This tool is very simple to use and effectively speeds production. However, ease of use and routine production work may invite accidents. Please practice safe work habits at all times and always wear ANSI approved safety equip- ment.
Figure 6 shows pressing down on the safety stop and
sliding the nails out.
G3690 Grizzly Imports, Inc. - 5 -