Continuous nailing and trigger locking method For continuous nailing, set the change lever to the ”Continuous Nailing” position. For locking the trig- ger, set the change lever to the ”Lock” position. Always make sure that the change lever is properly set to the position.
CAUTION:I
Operating the tool without nails shortens the life of the tool and should be avoided.
Air exhaust
Air exhaust direction can be changed easily by rotat- ing the exhaust cover. Change it when necessary.
. I. . . .
Jammed nailer
CAUTION:
Always lock the trigger, disconnect the hose and remove the nails from the magazine before cleaning a jam.
When the nailer becomes jammed, proceed as fol- | mr Small rod |
lows: | |
Open the door and magazinecap and removethe nail | |
coil. Inserta small rod or the like into the ejection port |
|
and tap it with a hammer to drive out the nail jam- |
|
ming the ejection port. Reset the nail coil and close |
|
the magazine cap and door. |
|
Hook
The hook is convenient for hanging the tool tempo- rarily. This hook can be installed on either side of the tool.
CAUTION:
=Always lock the trigger and disconnect the hose when hanging the tool using the hook. =Always tighten the hook securing bolt firmly. Loose bolt may cause air leakage from the tool.
14