Repair
P 6/ 15
[3]DISASSEMBLY/ASSEMBLY
[3]-5. Spring Section (cont.)
DISASSEMBLING
(3) Disassemble the Spring section in order of Fig. 19, 22. Spring section is removed as drawn in Fig. 23.
Fig. 19 | Fig. 20 |
Guide bolt
Wrench 8 
Turn guide bolt counterclockwise while gripping holder by a gloved hand and remove M6 hex nut, Holder with Rail and
Flat washer 6 from Guide bolt.
Cushion |
Rail
Holder
Flat washer 6
M6 Hex nut
Guide bolt
Cushion 
Hammer
Cushion is fit into the groove of Guide bolt firmly. Therefore, twist Cushion to pull it off from the groove.
Fig. 21
Compression
spring 17
Spring holder
Turn compression spring 17 counterclockwise while holding Spring holder with gloved hands.
Spring holders is removed from Compression spring 17.
Fig. 22
Flat washer 8
Spring holder
Guide bolt
After removing Guide bolt and Flat washer 8, remove Spring holder of the opposite side in the same way drawn in Fig. 21.
Note: When inserting Spring holder into Compression spring 17, turn Compression spring 17 clockwise and twist Spring holder to set in place.
Fig. 23
M6 Hex. nut | Holder | Rail | Flat washer 6 | Cushion |
|
|
|
| Hammer |
| |
|
|
|
|
| |
|
|
|
| Flat washer 8 | |
Spring holder | Compression spring 17 | Spring holder | Guide bolt | ||