Makita BPT351 specifications Magazine, Disassembling

Repair

P 11/ 15

[3]DISASSEMBLY/ASSEMBLY

[3]-7. Magazine

DISASSEMBLING

(1)Loosen M4x6 Hex socket head bolt three turns, then pull out Upper rail section from Magazine . (Fig. 44)

(2)Remove large Compression spring 3 that is put on Nail guide holder. (Fig. 45)

(3)Remove Stopper with small Compression spring 3 from Pusher. (Fig. 45)

(4)Pusher is just inserted into the slit of Shoulder pin 5-7. Therefore, Pull Pusher out straight from the slit side of Shoulder pin 5-7. (Fig. 45)

(5)Loosen M4x10 Pan head screw three turns so that Upper rail section has a clearance to push down three Nail stoppers and remove their hooks from Nail guide holder in the next step.

Note: Do not remove the screw. This is because the complete removing will cause the removal of Slide door cap and all the small Springs in the magazine section.

Fig. 45 Fig. 46

Fig. 44

M4x6

Hex

socket

head bolt

Magazine

Upper rail section

Action (3)		Action (4)
	Pusher	Pusher
Stopper
Compression
spring 3
Action (2)			M4x10 Pan
		Shoulder pin 5-7	head screw
			Upper rail complete
Compression spring 3 put on the rod of Nail guide holder

(6)Remove three Nail stoppers in order. Push each Nail stopper with Slotted screwdriver to remove the hook from the slot of each Nail stopper. (Fig. 47)

Nail guide holder is removed.

(7)Use 1R266 to remove Spring pin 2-8. (Fig. 48) Use 1R267 to remove Spring pins 3-10 and 3-18. (Fig. 49)

Fig. 47

Slotted	Nail stopper (3pcs.)	Leaf spring
screwdriver
		three hooks of Nail stoppers
three slots of Nail guide holder to hook the Nail stopper
Fig. 48	Fig. 49
	Spring pin 2-8	Spring pin 3-18	Spring pin 3-10