Woodstock W1764 manual Setup, Unpacking, Box Inventory Figures 3 Qty

W1764 Power Feeder

SETUP

SETUP

Unpacking

This machine has been carefully packaged for safe trans- portation. If you notice the machine has been damaged during shipping, please contact your authorized Shop Fox dealer immediately.

Inventory

The following is a description of the main components shipped with the Model W1764. Lay the components out to inventory them.

Note: If you can't find an item on this list, check the mounting location on the machine or examine the pack- aging materials carefully. Occasionally we pre-install cer- tain components for safer shipping.

Box Inventory (Figures 3 & 4)		Qty
A.	Base	1
B.	Arm Bracket	1
C.	Power Feeder Unit	1
D.	Arm	1
E.	Base Mounting Template	1
F.	Elbow Clamp Assembly	1
G.	Ball Joint Assembly	1
H.	Hardware Bag (Figure 4)	1
	—Cap Screw M10-1.5 x 25mm (Elbow Clamp)	1
	—Hex Bolt M10-1.5 x 50mm (Elbow Clamp)	3
	—Lock Lever (Arm Bracket Clamp)	1
	—Hex Nut M8-1.25mm (Arm Bracket Clamp)	1
	—Flat Washer 8mm (Arm Bracket Clamp)	1
	—T-Handle and Pivot Bar (Ball Joint Assembly)	1
	—Hex Bolt M10-1.5 x 35mm (Base)	4
	—Lock Washer 10mm (Base)	8
	—Hex Nut M10-1.5mm (Base)	7

Keep machine disconnected from power until instructed otherwise.

	C
B

A

D

		G
E	F
			H

Figure 3. Box inventory.

H

Figure 4. Hardware inventory.

-10-