Woodstock W1764 manual Setup

W1764 Power Feeder
9.	Place the arm into the arm bracket so the teeth of	Arm Bracket	Arm
	the gear and arm mesh as shown in Figure 8.
	Note: No lubrication is required for the gear or rack
	teeth. Oil or grease will gather debris making the
	horizontal adjustment of the power feeder difficult.
10.	Secure the arm bracket cover onto the arm bracket
	with three M10-1.5 x 35 hex bolts and washers
	(Figure 9).
	Note: Make sure that you do not tighten the hex
	bolts so much as to prevent the arm from sliding	Spline
	in and out of the arm bracket when the horizontal
	crank is turned.	Figure 8. Arm bracket gearing.

11.Insert the horizontal crank completely so it engages the spline (Figure 8) in the gear.

12.Insert the lock lever, flat washer, and hex nut as shown in Figure 9.

13.Place the E-clip on the end of the horizontal crank to retain the crank as shown in Figure 10.

14.Turn the horizontal crank to make sure that the cover bolts are not too tight or too lose. Adjust the three hex bolts as required to achieve a slight drag between the arm and arm bracket.

Lock Lever
Flat Washer
Hex Nut	SETUP
Arm Bracket
Cover
Horizontal Crank

Figure 9. Assembling arm bracket.

Continued on next page

E-Clip

Figure 10. Horizontal movement handle

E-clip.

-13-