W1764 Power Feeder
SERVICE
General
This section covers the most common service adjustments or procedures that may need to be made during the life of your machine.
If you require additional machine service not included in this section, please contact Woodstock International Technical Support at (360)
Wheel Replacement
If you damage one or more wheels, you can easily replace the wheels.
To replace a wheel, do these steps:
1.DISCONNECT THE FEEDER FROM POWER!
2.Using a #2 Phillips screw driver, remove the three cover screws and the cover (Figure 18).
3.Put on your safety glasses and remove the retaining ring (Figure 18) using external retaining ring pliers.
4.Replace the wheel and reassemble the power feed- er.
Brush Replacement
After a long period of time you may notice the motor lose some power or begin to growl during operation. This indi- cates that the motor brushes are worn and need replace- ment. The brushes can be easily replaced.
To replace the brush set, do these steps:
1.DISCONNECT THE FEEDER FROM POWER!
2.Using a standard #2 screw driver, unscrew both brush caps (Figure 19).
3.Replace the brush set (Figure 19) and reinstall the caps.
Make sure that your machine is unplugged during all service proce- dures! If this warning is ignored, seri- ous personal injury may occur.
Figure 18. Wheel replacement.
Figure 19. Brush set replacement.
SERVICE