Woodstock W1764 manual Assembly, To assemble the power feeder, do these steps

W1764 Power Feeder

SETUP

Assembly

To correctly position this power feeder on your table top, completely assemble the power feeder first, then refer to Base Mounting on Page 15. The reason for this order, is that with the power feeder unit completely assembled, it will be easier to locate where on the table top you will need to drill your base mounting holes, so you can take advantage of the full range of power feeder swing and adjustments.

To assemble the power feeder, do these steps:

1.Oil the T-handle threads and position the elbow clamp assembly onto the feeder base as shown in

Figure 5.

2.Thread the T-handle into the feeder base until the elbow is snug.

3.Insert the arm into the ball-joint ball and secure both together with the M10-1.5 x 25mm cap screw shown in Figure 6.

4.Insert the ball joint assembly into the power feed socket shown in Figure 6.

5.Insert the ball-joint socket into the power feed sock- et as shown in Figure 7, so it rests against the ball- joint ball.

Note: Lubrication is not necessary for the ball joint assembly.

6.Align the ball-joint socket with the power feeder socket and insert the pivot bar as shown in Figure 7.

7.Lightly oil the T-handle threads.

8.Thread the T-handle through the pivot bar so the end of the T-handle bolt presses against the ball- joint socket firmly as shown in Figure 7.

Continued on next page

T-Handle

Elbow

Clamp

Feeder

Base

Figure 5. Assembled elbow clamp

assembly.

Power Feed
Socket
Arm	Ball-Joint Ball
	Cap Screw

Figure 6. Arm, ball joint and socket

assembly.

Ball-Joint Socket

T-Handle

Pivot Bar

Figure 7. Assembled ball joint assembly.

-12-