Woodstock W1821 owner manual Dust port installed Guard Bracket

Model W1821 (For Machines Mfg. Since 3/10)

SETUP

DO NOT operate the attached router without an adequate dust collection system. Follow your router manufacturer's specifications for the required dust collection capacity. Failure to use a dust collection system can result in short and long-term respiratory illness.

11.Attach the dust port to the back of the fence assembly with the (4) M6-1 x 10 cap screws and (4) 6mm flat washers, as shown in Figure 14.

12.Slide the attached square nut on the guard bracket into the top fence T-slot, center it with the dust hood and dust port, then tighten the cap screw to secure it in place, as shown in Figure 15.

Dust Port

Figure 14. Dust port installed.

Guard Bracket

Figure 15. Guard bracket attached to the

fence.

To reduce the risk of hand injury from accidental contact with the spinning router bit, with the exception of freehand routing, ALWAYS make sure the fence and router guard are properly positioned and secured before connecting the router to power.

13.Attach the plastic router guard to the guard bracket with the (2) star knob bolts, as shown in Figure 16.

-10-

Star Knobs

Router

Guard

Figure 16. Router guard installed.