Model W1821 (For Machines Mfg. Since 3/10)
Tip: As an alternative to fabricating a custom jig, use the Shop Fox Model W1500 Right Angle Jig, as shown in Figure 26.
3.Remove the fence assembly from the table.
4.Fabricate and mount a custom guard over the bit that safely protects your hands from the spinning cutter.
5.Insert the starting pin in the best suited hole on the routing table or clamp a starting block to the table (see Figure 25 on the previous page for an example).
OPERATIONS
6.Install a router bit with a rub collar as directed by the router manufacturer's instructions, then raise it to the desired height (see Figure 27).
7.Connect the router to power and turn it ON.
8.Rest the jig with the workpiece attached against the starting pin or block, then slowly pivot and feed it into the bit. After the cut is started, move the jig against the rub collar and away from the starting pin or block, as illustrated in Figure 24 on the previous page.
Figure 26. Shop Fox Model W1500 Right
Angle Jig.
Template | Rub |
Collar | |
Workpiece |
|