Model W1821 (For Machines Mfg. Since 3/10)
Operation Overview | Workpiece Inspection |
This overview outlines you the basic process that happens during an operation with the router table attachment. Familiarize yourself with this process to better understand the remaining parts of the Operation section.
To complete a typical operation, the operator does the following:
1.Examines the workpiece to make sure it is suitable for cutting.
2.Adjusts the fence boards close to the bit for maximum workpiece support, and then secures the fence boards in place.
3.Adjusts the bit height for the desired cutting profile.
4.Adjusts the fence position to establish the depth of cut.
5.Wears safety glasses and a respirator, and locates push sticks if needed.
6.If using a reversible router, verifies that the direction of spindle rotation is correct, and then starts the router.
7.Holds the workpiece firmly and flatly against the fence, and then pushes the workpiece into the bit at a steady and controlled rate until the workpiece moves completely beyond it.
Important: The operator is very careful to keep the workpiece firmly against the table and fence during the entire cut. For smaller workpieces or
8.Stops the router.
Some workpieces are not safe to cut or may require modification before routing. Before routing, inspect all workpieces for the following:
•Material Type: This router is intended for cutting natural and
•Foreign Objects: Nails, staples, dirt, rocks and other foreign objects are often embedded in wood. While shaping, these objects can become dislodged and hit the operator, cause kickback, or break the bit, which might then fly apart. Always visually inspect your workpiece for these items.
If they can't be removed, DO NOT cut the workpiece.
•Large/Loose Knots: Loose knots may dislodge during a cutting operation. Knots can cause kickback and machine damage. Choose workpieces that do not have large/ loose knots or plan ahead to avoid shaping through them.
•Wet or "Green" Stock: Routing wood with a moisture content over 20% causes unnecessary wear on the cutters, increases the risk of kickback, and yields poor results.
•Excessive Warping: Workpieces with excessive cupping, bowing, or twisting are dangerous to cut because they are unstable and often unpredictable when being shaped. DO NOT process workpieces with these characteristics unless you properly square up the stock with a jointer and planer.
•Minor Warping: Workpieces with slight cupping can be safely supported if the cupped side is facing the table or the fence. A workpiece supported on the bowed side will rock during a cut and could cause kickback or severe injury.