Woodstock D2796 manual Template Adjustment, To adjust the template to the proper position

Page 12

ADJUSTMENTS

TEMPLATE ADJUSTMENT

The template is adjustable from front to back so that the 3.

For side pieces thicker than 7/8", add 1/8" to the

joint will be hidden when the dovetails are complete.

amount that the board exceeds 7/8". Then, set the

Adjustment is made by loosening the two template lock

front edge of the template fingers back from the

knobs. Do not adjust the screws holding the template.

edge by that sum. See Figure 13 and 14.

To adjust the template to the proper position:

 

1.Mount your drawer pieces in the jig. The horizon- tal piece must be tight and flush with the top of the vertical piece. When mounted correctly, the top edge of the vertical piece sits flush with the top of the horizontal piece. See Figure 11.

 

y

 

A

1/8" + y

7/8"

 

 

y = (Thickness of A) - 7/8"

 

 

 

 

 

 

 

Figure 13. Correct template adjustment for stock thicker

 

Figure 11 shows the proper positioning between the hori-

 

than 78".

 

zontal and vertical workpieces when mounted in the dove-

 

 

 

tail jig.

 

 

 

 

2.For side pieces that are 7/8" thick and less, slide the template so the front edge of the template fingers are 1/8" back from the top edge of the vertical piece. See Figure 12.

1/8"

7/8" or Less

Figure 14 shows the template set back an additional 1/8" for

a 1" thick board. The inside faces are showing.

Figure 12. Correct template adjustment for stock 78" thick

and less.

- 10 -

Woodstock Intl., Inc. D2796

Image 12
Contents Dovetail JIG D2796 Operating Manual Page Table of Contents Introductioncommentary Safety Rules for ALL Tools Keep ALL Guards in Place and in work- ing orderAssembly UnpackingHand Levers Bench MountingAssembly CapacitiesPreparation It is important to plan your work before startingAdjustment Locations Shows the adjustment locations for the dovetail jigClamp Adjusting Side Stop SET UPOffset the two drawer pieces by width of a tem Plate finger Template Adjustment To adjust the template to the proper positionMake sure template is parallel to drawer edges Fence Adjustment Adjust the fence accordingly. See FigureFence Adjustment Table Operations HALF-BLIND JointsTo use the dovetail jig Tips for Optimum Results Shows a finished drawer 2 sides ready to be joinedHALF-BLIND Joints on RABBET- ED Drawer Fronts To produce half-blind dovetails on rabbeted drawer frontsTrouble Shooting TEAR-OUTExcessive FIT Incomplete FITOffset Edges FIT TOO Tight or TOO LooseUneven FIT Shows uneven fitWarrantyclosure Limited WarrantyIntroduction Parts Diagram Parts List Tool DataD2796 Dovetail JIG Woodstock Intl., Inc. D2796