Woodstock D2796 manual Table of Contents

Page 3

TABLE OF CONTENTS
INTRODUCTION	2
COMMENTARY	2
SAFETY RULES FOR ALL TOOLS	3
UNPACKING	4
ASSEMBLY	4
HAND LEVERS	4
MOUNTING	4
CAPACITIES	5
PREPARATION	6
ADJUSTMENT LOCATIONS	7
CLAMP ADJUSTING	8
SIDE STOP SET UP	8
TEMPLATE ADJUSTMENT	10
FENCE ADJUSTMENT	12
FENCE ADJUSTMENT TABLE	13
OPERATIONS	14
HALF-BLIND JOINTS	14
RABBETED DRAWER FRONTS	16
TROUBLESHOOTING	17
TEAR OUT	17
EXCESSIVE FIT	17
INCOMPLETE FIT	17
OFFSET EDGES	18
FIT TOO TIGHT OR TOO LOOSE	18
UNEVEN FIT	19
WARRANTY	20
CLOSURE	20
PARTS DIAGRAM	21
PARTS LIST	22
TOOL DATA	22

COPYRIGHT © BY WOODSTOCK INTERNATIONAL, INC. TX 4-085-998

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

REVISED APRIL 2001, PRINTED IN TAIWAN

Woodstock Intl., Inc. D2796

- 1 -

INTRODUCTION SAFETY

ASSEMBLY ADJUSTMENTS OPERATIONS

PARTS

Image 3

Contents Dovetail JIG D2796 Operating Manual Page Table of Contents Introductioncommentary Keep ALL Guards in Place and in work- ing order Safety Rules for ALL ToolsBench Mounting AssemblyUnpacking Hand LeversCapacities AssemblyIt is important to plan your work before starting PreparationShows the adjustment locations for the dovetail jig Adjustment LocationsSide Stop SET UP Clamp AdjustingOffset the two drawer pieces by width of a tem Plate finger To adjust the template to the proper position Template AdjustmentMake sure template is parallel to drawer edges Adjust the fence accordingly. See Figure Fence AdjustmentFence Adjustment Table Operations HALF-BLIND JointsTo use the dovetail jig Shows a finished drawer 2 sides ready to be joined Tips for Optimum ResultsTo produce half-blind dovetails on rabbeted drawer fronts HALF-BLIND Joints on RABBET- ED Drawer FrontsIncomplete FIT Trouble ShootingTEAR-OUT Excessive FITFIT TOO Tight or TOO Loose Offset EdgesShows uneven fit Uneven FITWarrantyclosure Limited WarrantyIntroduction Parts Diagram Parts List Tool DataD2796 Dovetail JIG Woodstock Intl., Inc. D2796