Campbell Hausfeld FP2040 operating instructions Operation, BREAK-IN Procedure, Wiring, Lubrication

				FP2040
Installation		Handle
(Continued)
! DANGER			ON/OFF Switch
Improper use of
grounding plug can result
in a possible risk of
electrical shock!			Regulator
! DANGER	Do not use a
	grounding adapter
with this product!
2. If repair or replacement of cord or plug
is necessary, do not connect grounding		Safety Valve
wire to either flat blade terminal. The
wire with insulation having an external		Drain Petcock
surface that is green (with or without
yellow stripes) is the grounding wire.
	Never connect	Figure 2 - Unit Identification
! WARNING
	green (or green and	device occurs, it may be necessary to	BREAK-IN PROCEDURE
yellow) wire to a live terminal.
				Do not attach air
		operate compressor from a 120 volt, 20
			! CAUTION
3. Check with a qualified electrician or		amp circuit.		chuck or other tool
serviceman if grounding instructions			to open end of hose until start-up has
			been completed and unit checks OK.
are not completely understood, or if in		Operation
			IMPORTANT: Do not operate
doubt as to whether product is
properly grounded. Do not modify		Regulator - The regulator controls the	compressor before reading instructions
			or damage may result.
plug provided; if it will not fit outlet,		amount of air pressure released at the
have proper outlet installed by a		hose outlet.	1. Turn regulator fully clockwise to
qualified electrician.		ASME Safety Valve - This valve	open air flow.
WIRING		automatically releases air if the tank	2. Turn switch to OFF position and plug
		pressure exceeds the preset maximum.
			in power cord.
		Handle - Designed to move the
! CAUTION	Overheating, short
		compressor.	3. Turn switch to ON position and run
	circuiting and fire
damage will result from inadequate		Drain Petcock - This valve is located on	unit for 5 minutes to break in the
wiring, etc.		the bottom of the tank. Use this valve	pump parts.
NOTE: 120 volt, 15 amp units can be		to drain moisture from the tank daily	4. Turn regulator knob fully
operated on a 120 volt circuit under the		to reduce the risk of corrosion.
			counterclockwise. Compressor will
following conditions:		Reduce tank pressure below 10 psi,
			build to maximum preset pressure
a. No other electrical appliances or lights		then drain moisture from tank daily to
			and shut off.
are connected to the same branch		avoid tank corrosion. Drain moisture
circuit.		from tank(s) by opening the drain	5. Turn regulator knob clockwise to
b. Voltage supply is normal.		petcock located underneath the tank.	cause air to bleed off. Compressor
c. Circuit is equipped with a 15 amp		LUBRICATION	will restart at a preset pressure.
circuit breaker or a 15 amp slow blow			6. Turn regulator knob
fuse.		This is an oilless product and DOES
			counterclockwise to shut off the air
If these conditions cannot be met or if		NOT require lubrication to operate.
			and turn switch to Off position.
nuisance tripping of current protection

			Extension cords for 120V/8 Amp Unit
Length of Cord (ft)	25	50	100	150	200	250	300	400	500
Gauge of Cord	18	14	12	10	8	8	6	6	4

www.chpower.com

3