RIDGID R2610 manual Operating the Sander, Emptying the Dust BAG

Page 13

OPERATION

WARNING:

Before connecting the sander to a power supply, make sure it is not in the locked-on position. Failure to do so could result in accidental starting of the tool resulting in serious injury.

To lock on the sander:

nDepress the trigger switch.

nPush in the lock-on button.

nRelease the trigger switch.

nRelease the lock-on button.

NOTE: To release the lock, depress the trigger switch.

OPERATING THE SANDER

See Figure 9.

To operate the sander:

nSecure the workpiece to prevent it from moving under the sander.

AIR VENTS

Fig. 9

DUST BAG

WARNING:

Unsecured workpieces could be thrown towards the operator causing injury.

WARNING:

Keep your head away from the sander and the sanding area. Your hair could be drawn into the sander causing serious injury.

nPlace the sander on the workpiece so that all of the sanding disc surface is in contact with the workpiece.

CAUTION:

Be careful not to let your hand cover the air vents.

nTurn on the sander and move it slowly over the workpiece.

nMake successive passes in parallel lines, circles, or crosswise movements.

nTurn off the sander and wait until the sanding disc comes to a complete stop before removing it from the workpiece.

EMPTYING THE DUST BAG

See Figure 10.

For more efficient operation, empty the dust bag when it is no more than half full. This will permit the air to flow through the bag better. Always empty and clean the dust bag thoroughly upon completion of a sanding operation and before placing the sander in storage.

Fig. 10

WARNING:

Collected sanding dust from sanding surface coatings such as polyurethanes, linseed oil, etc. can self-ignite in the sander dust bag or elsewhere and cause fire. To reduce the risk of fire always empty the dust bag frequently (10-15 minutes) while sanding and never store or leave a sander without totally emptying its dust bag. Also follow the recommendations of the coatings manufacturers.

To empty the dust bag:

nUnplug the sander.

nRemove the dust bag from the sander.

nRemove the dust bag from the dust bag support.

nUnzip the dust bag.

nShake out the dust.

nInstall the dust bag on the dust bag support. Refer to “Attaching the Dust Bag” earlier in this manual.

nAttach the dust bag support to the sander.

13

Image 13
Contents Double Insulated Variable Speed OPERATOR’S ManualIntroduction Table of ContentsElectrical Safety General Safety RulesPersonal Safety Work AreaService Specific Safety RulesSymbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Double Insulation ElectricalElectrical Connection Extension CordsProduct Specifications FeaturesKnow Your Random Orbit Sander SwitchLOCK-ON Variable SpeedOperation AssemblyAdjusting the Speed Adjusting the Orbit DiameterAttaching Velcro Sanding Discs Attaching the Sander to a Vacuum Attaching the Dust BAGTurning ON/OFF the Sander Locking on the SanderEmptying the Dust BAG Operating the SanderBrush Replacement MaintenanceDAY Satisfaction Guarantee Policy WarrantyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information