Power Supply and Motor Specifications

Safety Instructions (continued)

Warning Labels

Find and read all warning labels found on

Motor Specifications and Electrical Requirements

Power Supply and Motor Specifications

the air compressor shown below

!WARNING

To reduce the risk of electrical hazards, fire hazards or damage to the tool, use proper circuit protection. Your tool is wired at the factory for operation using the voltage shown. Connect tool to a power line with the appropriate voltage and a 15- amp branch circuit. Use a 15- amp time delay type fuse or cir- cuit breaker. To reduce the risk of shock or fire, if power cord is worn or cut, or damaged in any way, have it replaced immedi- ately.

The A-C motor used on this tool has the following specifications. It is wired at the factory for operation on 110V-120V AC, 60 Hz service.

	Wired for 120V
Rated HP	1 1/2
Voltage	110-120
Amperes	13
Hertz (Cycles)	60
Phase	Single
RPM	3450
Rotation of Shaft	Clockwise

DK724100AV

1000

Figure 1

General Electrical Connections

!DANGER

To reduce the risk of electrocu- tion:

1.Use only identical replace- ment parts when servicing. Servicing should be per- formed by a qualified techni- cian.

2.Do not use in rain or where floor is wet. This too is intended for indoor residen- tial use only.

!WARNING

Do not permit fingers to touch the terminals of plug when installing or removing the plug to or from the outlet.