RIDGID R83001 Reversible, TWO-SPEED Gear Train, TWO Speed Gear Train HI-LO, HI 2 Speed Auxiliary

REVERSIBLE

See Figure 4.

TWO SPEED

GEAR TRAIN (HI-LO)

This tool has the feature of being reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.

CAUTION:

To prevent gear damage, always allow chuck to come to a complete stop before changing the direction of rotation or the two speed gear train (hi-lo).

To stop, release switch trigger and allow the chuck to come to a complete stop.

TWO-SPEED GEAR TRAIN

HI 2 SPEED

AUXILIARY

1

LO

SPEED

Fig. 7

See Figure 7.

Your drill has a two-speed gear train designed for drilling or driving at LO (1) or HI (2) speeds. A slide switch is located on top of your drill to select either LO (1) or HI (2) speed. When using drill in the LO (1) speed range, speed will decrease and unit will have more power and torque. When using drill in the HI (2) speed range, speed will increase and unit will have less power and torque. Use LO (1) speed for high power and torque applications and HI (2) speed for fast drilling or driving applications.

AUXILIARY HANDLE

See Figure 8.

An auxiliary handle is packed with the drill for ease of op- eration and to help prevent loss of control.

To use the auxiliary handle:

nOpen the clamping ring by turning the handle counter- clockwise.

nSlide the ring of the auxiliary handle onto the spindle col- lar of the machine behind the torque adjustment ring.

nTighten the auxiliary handle at the desired angle by turn- ing the handle clockwise.

Note: For convenience the screw has been trapped inside the auxiliary handle.

To prevent thread damage and possible loss of control, the auxiliary handle should be checked periodically for tightness. Do not operate the drill with the handle loose.

HANDLE ASSEMBLY

TO

TOLOOSEN

TIGHTEN

Fig. 8