Emerson CF4600GLZ00, CF4600WB00 warranty Setting Operating Frequency of Wall Control and Receiver

BP7306 Nottingham 6/19/06 1:00 PM Page 13

Setting Operating

Frequency of Wall

Control and Receiver

(Figure 17)

Your wall control and receiver have code switches which must be set in one of 16 possible code combinations. The four levers (numbered 1, 2, 3, and 4) on the switches are factory-set in the ON (up) position. Change the switch settings as follows:

1. Slide the four switch levers in the wall control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

2. In the receiver, slide the four switch levers to the same positions as set in the wall control. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate.

ANTENNA WIRE

ON

RECEIVER	CODE	WALL CONTROL
	SWITCH	LEVERS
		4	3	2	1
RECEIVER					ON
SWITCH LEVERS

1	2	3	4	CODE
ON				SWITCH
WALL
CONTROL

Installation of Wall

Control

SINGLE-POLE INSTALLATION

(Figure 18)

HOT	BLK	FAN/LIGHT
		WALL CONTROL
	EMERSON	BLACK
		BLACK	LOAD
NEUTRAL			GROUND
REMOTE CONTROL
RECEIVER LOCATED
WITHIN THE CEILING
COVER

Figure 18

1. Disconnect power at circuit breaker or remove fuse.

2. Remove faceplate and screws from existing wall control. Pull control out from the wall box. Determine the “hot” wire and the “load” wire and disconnect these wires from control. Do not attempt to disconnect any wires not already connected to existing control.

3. Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position.

!WARNING

Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control.

4. Connect one black wire of wall control to the “hot” wire. Securely connect wires with wire connectors supplied (Figure 19).

Figure 17	5. Connect one black wire of wall switch
	to the “load” (black) wire in wall box.
	Securely connect wires with wire
	connector supplied.

13