Emerson CF4600GLZ00, CF4600WB00 warranty Pin

BP7306 Nottingham 6/19/06 1:00 PM Page 7

PIN	DOWNROD
	CLEVIS
HANGER	PIN
BALL
DOWNROD	SETSCREW

HAIRPIN

CLIP

MOTOR COUPLING

Figure 5

8. Separate, untwist and unkink the three motor leads. Route the motor lead wires through the downrod and seat the downrod in the motor coupling (Figure 6).

9. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 6). (Pin and clip are supplied in loose parts bag.) The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull up on the downrod to make sure the clevis pin is properly installed.

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 6) could result in the fan falling.

5/16-18 x 1/4"

SETSCREW

Figure 6

10. Install the 5/16-18 x 1/4” setscrew (supplied) in the motor coupling (Figure 6). While pulling up on the downrod, tighten the setscrew using the 4 hex wrench (supplied).

NOTE: The setscrew must be properly installed as described above, or fan wobble could result.

11. Screw two 1” threaded studs (sup- plied) into the motor (Figure 7). Leave approximately 7/8” of the stud extending above the motor. Coil the wires and wire connectors around the motor coupling then slide the coupling cover over the downrod and rotate the cover until the threaded studs protrude. Install two lockwashers and knurled knobs (supplied) to secure the cover to the motor. All wires and wire connectors must be enclosed under the coupling cover.

7