Emerson CF4600GLZ00 Operating Your Ceiling Fan, Standard Wiring for Existing 3-WAY Control

BP7306 Nottingham 6/19/06 1:00 PM Page 15

STANDARD WIRING FOR EXISTING 3-WAY CONTROL

		EXISTING
HOT	BLK	WALL CONTROL
				BLACK
	TRAVELER WIRES			LOAD
	BLK	BLK		BLK
HOT	BLK
	EMERSON		EMERSON	BLACK
FAN/LIGHT
WALL CONTROL		TRAVELER WIRES		LOAD

Figure 21

Operating Your

Ceiling Fan

4. To set the level of housing light brightness, press and hold the LIGHT button. The light brightness will continue to increase then decrease while the button is held down. When the light is at the desired brightness, release the button.

5. To turn the housing lights on and off, press and release the LIGHT button. The light will turn on at the light level previously set (see step 4).

6. If airflow is desired in the opposite direction, turn the fan off and wait for the blades to stop turning. Then slide the reversing switch to the opposite position (Figure 23) and turn the fan on again. The blades will turn in the opposite direction and reverse the airflow.

IMPORTANT

Fan installation must be completed, including the installation of the fan blades, before testing of the remote control.

Your Fan/Light Wall Control (Figure 22) has full control of your fan and light. However, airflow direction is controlled by a slide switch on the switch housing.

1. Restore electrical power to the outlet box by turning the electricity on at the service panel.

NOTE: Make sure that the ON/OFF slide switch on the Fan/Light Wall Control is in the ON position.

2. To set the desired fan speed, press the HI, MED, or LOW buttons to operate your fan on high, medium, or low speed (Figure 22).

3. To turn your fan off, press the OFF button.

Figure 22

REVERSING SWITCH

Figure 23

HI

LIGHT

MED

LOW

FAN OFF

EMERSON®

OFF ON

15