Emerson CF4600WB00 Replacing Light Bulbs Attaching Light Kit, Maintenance, For your Ceiling Fan

BP7306 Nottingham 6/19/06 1:00 PM Page 16

Replacing Light Bulbs Attaching Light Kit

To replace a burned out light bulb, loosen the setscrew in the upper housing and raise the upper housing/glass enough to access the defective bulb, then tighten the setscrew (Figure 24). Unscrew the defective bulb and screw in the replacement 7-watt (maximum) candel- abra bulb. Firmly grasp the housing trim to prevent the upper housing/glass from falling down the downrod and damaging the glass, then loosen the setscrew. Carefully lower the upper housing/glass until the glass seats evenly in the lower housing flange. Tighten the setscrew.

UPPER

HOUSING/GLASS

HOUSING

TRIM

SETSCREW

7-WATT (MAXIMUM)

CANDELABRA BULB (6)

LOWER

HOUSING

FLANGE

Figure 24

CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan and optional light kit and/or remote control receiver.

To install an optional Emerson light kit, remove the four screws securing the switch cup assembly to the switch cup adapter. Remove the finial nut from the switch cup and install the light kit in accordance with the light kit Owner’s Manual.

!WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main service box before wiring.

Maintenance

IMPORTANT CARE INSTRUCTIONS

for your Ceiling Fan

Periodic cleaning of your new ceiling fan is the only maintenance that is needed.

When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.

Abrasive cleaning agents are not required and should be avoided to prevent damage to finish.

!WARNING

Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock.

16