OPERATION
WARNING:
Disconnect the tool from the air supply before removing nails or clearing a jammed fastener. Failure to do so could result in serious personal injury.
REMOVING NAILS FROM THE TOOL
See Figure 12.
nDisconnect the tool from the air supply.
nTo� remove a strip of nails from the tool, press the release button on the pusher. When released, the pusher will slide forward.
NOTE: Always keep fingers clear of nail track of magazine to prevent injury from unintended release of the pusher.
nPress down on the nail stop tab near the end of the magazine and slide the nails over the tab.
nRemove the nail strip from the tool.
CLEARING A JAMMED FASTENER
See Figure 13.
If a nail or fastener becomes jammed in the tool, disconnect the air hose and keep the tool pointed away from you while clearing the jam.
nDisconnect the tool from the air supply.
n�Remove fasteners from the tool.
nInsert a #2 Phillips screwdriver into the driving mecha- nism.
nTap the screwdriver gently with a hammer. The inserted screwdriver should push the driver blade back, freeing the nail jam.
nRemove the bent nail, using
nReconnect the tool to the air supply.
nReload the tool with nails.
NAIL STOP TAB
PUSHER
RELEASE
BUTTON
Fig. 12
Fig. 13
16