RIDGID R8452 manual LED Function of Charger, Defective Indicator Charging Full Indicator

Page 13

OPERATION

LED FUNCTION OF CHARGER

See Figure 5.

LED

BATTERY

RED

GREEN

ACTION

INDICATOR

PACK

LED

LED

 

Power

Without battery pack

ON

OFF

Ready to charge battery pack

 

 

 

 

When battery pack reaches cooled

Evaluate

Hot battery pack

Flashing

OFF

temperature, charger begins fast

 

 

 

 

charge mode.

 

 

 

 

When battery pack reaches warmed

Evaluate

Cold battery pack

Flashing

OFF

temperature, charger begins fast

 

 

 

 

charge mode.

 

 

 

 

Charger pre-charges battery until nor-

Evaluate

Deeply discharged

Flashing

OFF

mal voltage is reached, then begins

 

 

 

 

fast charge mode.

Defective

Defective

Flashing

Flashing

Battery pack or charger is defective

• If defective, try to repeat the conditions a second time by removing and reinstalling the battery pack. If the LED status repeats a second time, try charging a different battery.

• If a different battery charges normally, dispose of the defective pack (see Maintenance section).

• If a different battery also indicates “Defective,” the charger may be defective.

 

Charging

Fast charging

ON

Flashing See chart below for charge times

 

Full

Slow charging

OFF

ON

Fast charging is complete;

 

charger maintains charge mode

 

 

 

 

 

RED LED

GREEN LED

POWER

 

 

BATTERY

AVERAGE CHARGE TIME

 

 

 

 

 

 

INDICATOR

 

COMPACT SERIES

18 min.

 

 

EVALUATE

 

 

HC

27 min.

 

 

INDICATOR

 

 

HC 2.5

34 min.

 

 

 

 

 

DEFECTIVE

INDICATOR

CHARGING

INDICATOR

FULL INDICATOR

NOTE: The 9.6 Volt, 12 Volt, and 14.4 Volt battery packs will not slide all the way down onto the charger port. Insert 9.6 Volt, 12 Volt, and 14.4 Volt battery packs until they click into place and are aligned with the line on the charger, shown at left.

Allow up to 5 seconds for the “charge” light to come on after the battery pack is inserted.

Fig. 5

13

Image 13
Contents OPERATOR’S Manual Introduction Table of ContentsElectrical Safety General Safety RulesPersonal Safety Work AreaService Specific Safety RulesCauses and Operator Prevention of Kickback Additional Safety Rules Safety Rules for Charger Important Safety InstructionsName DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Features Assembly Removing the Blade Attaching the BladeInner Blade Washer Spindle Lock Button Spindle Lock Button Loosen HEX KEY TightenOperation LED Function of Charger Defective Indicator Charging Full IndicatorTo Remove Battery Pack To Install Battery PackSAW Blades Blade Guard SystemWrong KickbackSee Figures 8 Kickback Blade SET TOO Deep Incorrect SupportTo Adjust Blade Depth Depth of CUT AdjustmentLOCK-OFF Button Switch Trigger Depth Adjustment Knob STARTING/STOPPING the SAWRight Wrong Operating the SAWSee Figures 14 Cross CUTTING/RIP Cutting Using the Edge GuideSee Figures 16 TOP View of SAWBevel Cutting To Adjust Bevel SettingSee Figures 20 Positive 0 Bevel Stop To AdjustTo Check Bevel StopPocket Cutting General Maintenance MaintenanceBattery Pack Removal and Preparation for Recycling BatteriesDAY Satisfaction Guarantee Policy WarrantyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information