RIDGID R8452 manual Customer Service Information

Page 24

OPERATOR’S MANUAL

6-1/2 in. 18 VOLT CIRCULAR SAW

R8452

Customer Service Information:

For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you, please call 1-866-539-1710 or visit us online at www.ridgid.com.

The model number of this tool is found on a plate attached to the motor housing. Please record the serial number in the space provided below. When ordering repair parts, always give the following information:

Model No.	R8452

Serial No.

983000-898
3-24-06 (REV:02)	24

Image 24

Contents OPERATOR’S Manual Table of Contents IntroductionGeneral Safety Rules Electrical SafetyPersonal Safety Work AreaSpecific Safety Rules ServiceCauses and Operator Prevention of Kickback Additional Safety Rules Important Safety Instructions Safety Rules for ChargerSymbols Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Features Assembly Attaching the Blade Removing the BladeInner Blade Washer Spindle Lock Button Spindle Lock Button Loosen HEX KEY TightenOperation Defective Indicator Charging Full Indicator LED Function of ChargerTo Install Battery Pack To Remove Battery PackSAW Blades Blade Guard SystemKickback WrongSee Figures 8 Kickback Blade SET TOO Deep Incorrect SupportDepth of CUT Adjustment To Adjust Blade DepthLOCK-OFF Button Switch Trigger Depth Adjustment Knob STARTING/STOPPING the SAWOperating the SAW Right WrongSee Figures 14 Using the Edge Guide Cross CUTTING/RIP CuttingSee Figures 16 TOP View of SAWTo Adjust Bevel Setting Bevel CuttingSee Figures 20 To Adjust Positive 0 Bevel StopTo Check Bevel Stop Pocket Cutting Maintenance General MaintenanceBattery Pack Removal and Preparation for Recycling BatteriesWarranty DAY Satisfaction Guarantee PolicyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information