Configuration (DMX)
Starting
Address
Set the product in DMX mode to control with a DMX controller.
1.Connect the product to a suitable power outlet.
2.Turn the product on.
3.Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels the selected DMX mode uses. If you choose a starting address that is too high, you could restrict the access to some of the product’s channels.
The Eclipse™ RGB uses up to 12 DMX channels in its
If you are not familiar with the DMX protocol, you may refer to the DMX Primer section in the Technical Information chapter.
To select the starting address, do the following:
1.Press <MENU> repeatedly until 001 shows on the display.
2.Press <ENTER>.
3.Use <UP> or <DOWN> to select the starting address.
4.Press <ENTER>.
Eclipse™ RGB User Manual | 13 | 12/20/2011 |