Message Codes | Care | EN |
|
|
|
Functions
Distance measuring | yes |
Min/Max measuring | yes |
Permanent measuring | yes |
yes | |
Addition/Subtraction | yes |
|
|
Area | yes |
Triangle area | yes |
Volume | yes |
|
|
Trapezium | yes |
Painter function (area with partial | yes |
measurem.) |
|
Pythagoras | |
Smart Horizontal Mode / | yes |
Indirect height |
|
yes | |
Level | yes |
Sloped objects | yes |
|
|
Height tracking | yes |
Memory | yes |
Beep | yes |
|
|
Illuminated colour display | yes |
Multifunctional endpiece | yes |
Pointfinder (Viewscreen) | 4x zoom, OV |
Bluetooth® Smart | yes |
Personalized Favorites | yes |
Timer | yes |
Long Range Mode | yes |
Calculator | yes |
Photo/Screenshot | yes |
Compass | yes |
Gallery with USB download | yes |
Diameter | yes |
Width | yes |
Area from Photo | yes |
If the message Error does not disappear after switching on the device repeatedly, contact the dealer.
If the message InFo appears with a number, press the Clear button and observe the following instructions:
No. | Cause | Correction |
156 | Transverse tilt greater | Hold the instrument |
| than 10° | without any transverse tilt. |
|
|
|
162 | Calibration mistake | Make sure, the device is |
|
| placed on a absolutely |
|
| horizontal and flat surface. |
|
| Repeat the calibration |
|
| procedure. If the mistake |
|
| still occurs, contact your |
|
| dealer. |
204 | Calculation error | Perform measurement |
|
| again. |
240 | Data transfer error | Repeat procedure. |
|
|
|
252 | Temperature too high | Let device cool down. |
|
|
|
253 | Temperature too low | Warm device up. |
|
|
|
255 | Received signal too | Change target surface |
| weak, measuring time | (e.g. white paper). |
| too long |
|
|
|
|
256 | Received signal too | Change target surface |
| high | (e.g. white paper). |
|
|
|
257 | Too much back- | Shadow target area. |
| ground light |
|
|
|
|
258 | Measurement outside | Correct range. |
| of measuring range |
|
|
|
|
260 | Laser beam inter- | Repeat measurement. |
| rupted |
|
|
|
|
•Clean the device with a damp, soft cloth.
•Never immerse the device in water.
•Never use aggressive cleaning agents or solvents.
Warranty
Lifetime Manufacturer's Warranty
Warranty coverage for the entire usage time of the product according to Leica Geosys- tems International Limited Warranty. Free of charge repair or replacement for all products that suffer defects as a result of faults in mate- rials or manufacturing, for the entire life of the product.
3 Years No Cost
Guaranteed service should the product become defective and require servicing under normal conditions of use, as described in the user manual, at no additional charge.
To receive the "3 years no cost" period, the product must be registered at www.leica- geosystems.com/registration within 8 weeks of the purchase date. If the product is not registered, a "2 years no cost" period applies.
Leica DISTOTM D810 touch 799093a | 38 |
|
|